[. . . ] Never use the cord for carrying, pulling or unplugging the power tool. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. If operating a power tool in a damp location is unavoidable, use a ground fault circuit interrupter (GFCI) protected supply. [. . . ] Before starting work check to make sure that the trimmer is in good and safe working order. Always work in such a way that the extension power cord is behind you. Immediately switch off the motor and unplug the mains plug if the cutter should come into contact with a fence or other hard object. Before checking the cutter, taking care of faults, or removing material caught in the cutter, always switch off the trimmer and unplug the mains plug. Switch off the trimmer and disconnect and secure the mains plug before doing any maintenance work. When moving the hedge trimmer to another location, including during work, always unplug the mains plug. Clean the hedge trimmer and especially the cutter after use, and before putting the trimmer into storage for extended periods. The cover supplied with the unit can be hung on the wall, providing a safe and practical way to store the hedge trimmer. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. For your safety, this tool is equipped with a triple switching system. The sequence of switching is unimportant as the tool only starts when both switches are activated. Cut upwards with both hands pull the switch triggers B and C and move it in front of your body. To trim the hedge in far area with both hands pull the switch triggers A and C. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Do not attach the holder of waist cord hook to other than the extension cord. Do not attach it in a position closer to the tool beyond the hook complete. When using the waist cord hook, use the extension cord as a standard equipment. Using an extension cord available in the market may cause an accident or injury. â· Attach firmly one hook of the hook complete to the tool's cord and the other hook of hook complete to the extension cord. Working with the tool with a sole hook only attached may cause an accident and injury. Using the waist cord hook helps to minimizing a risk of cutting off the extension cord unexpectedly caused by the loose extension cord. [. . . ] Return the gear to the original position in such a manner as it was installed if it should be taken away by mistake. Installing the shear blade Prepare 4 removed screws (For under cover), 2 screws (For shear blade), gear housing cover, under cover, and new shear blades. At this time, apply some grease provided with new shear blades to the periphery of the crank. 26) Overlap the oval hole in the upper blade with that in the lower one. [. . . ]